Directions for use:
Surface must be dry, clean and free of existing coatings before applying. Prepare the surface of the wood by sanding with 220 grit sandpaper until smooth. Mix Color Oil well before and during application. Apply with a soft cotton rag, brush, or spray gun allowing the color to penetrate the wood for a few minutes to achieve desired color. Remove excess with a clean cloth wiping in the direction of the grain. For a deeper color or different effect, apply a second coat of color after 2-4 hours. Allow L.Co Color Oil to dry completely and seal with L.Co Tung Oil Finish, Topcoat or Exterior Varnish following directions on the label.
Clean application tools immediately with mineral spirits or turpentine. Properly dispose of rags, applicators and waste.
Coverage | Thinning:
4 Liters covers approximately 68 square meters per coat. One Liter covers approximately 17 square meters per coat. No thinning necessary.
Allow surface to dry 2-4 hours before applying additional coats. Poor ventilation, high humidity, cool temperatures and subsequent coats may have increased dry times. *See our support page for more information on drying and curing.
Mineral spirits, modified alkyd resin, raw tung oil, pigment, dryers.
Non-toxic when fully cured.